Wiring

Not a lot to show.  Just continued to lay out the wire.

The Wiring Kit Arrived this week

While I was waiting for the electrical to show up I started on the cowling.  I got it trimmed out pretty well and then I put a light coat of resin on the inside to help protect it.

This week my back order for the electrical kit arrived.  Before I can start laying wires, there are a few modifications I have to make. First I had to add a spot for the USB port. Then I had to drill out a circle of holes for some sort of cooling fan.

Next I had to add nutplates across the entire lower front panel of the instrument tray. Finally I had to change out the front and rear com support

Next, I drilled the holes for the magnometer

And finally I tipped the fuselage on it's side for better access while I put in the wires.
 

Installed the Map Holder

Installed the Map Holder

Installed the Elevator Pullys

Installed the Elevator Pullys

Finished Rigging the Rudder up

I finished connecting the rudder cables to the rudder

Tailcone Painted and installed

Now I will remove it and store it at the hanger

Installed the POH Tray

Last evening I installed the optional tray for holding the POH

Finished the Tailcone

I finished off the tailcone today.  I had to bring the Stabilator back from the hanger and assemble the tail feathers to check for clearance.  It all came out nice

Working on the Tail Cone and Rudder

I spent some more time with the tail cone today.  I got all the tabs installed and I just have a little finish sanding to do.  I installed the Rudder and and installing the cables.